![]() Push one of the clips from the webbing kit through one end of the webbing, 2 inches from the end. Add 4 inches to this measurement to calculate the length of the vertical straps.Ĭut your strips to these measurements. Measure the distance from the center hole on the front of the top of the seat, down around the metal bar at the back of the seat, and up to the center hole on the top of the front of the seat. Measure the distance between the holes for the vertical straps with the chair folded. Add 4 inches to this measurement to calculate the length of the horizontal straps. For the straps that run from one side of the chair to the other, measure the distance between corresponding holes on either side of the top of the seat. Measure the distance between the holes in the frame of the chair. Replace any other missing strips in the same way. Stick another screw through the strip so it aligns with the hole in the frame. Wrap the end of the strip around the other side of the frame. Be sure to go under the bar at the bottom (back) of the seat.įold the other end of the strip into another point with the folds facing down. Weave vertical strips with the chair folded. If the strips on either side go under weave it over, if they go over weave it under. Wrap the strip of webbing around the frame and weave it over and under every other strip. Screw it into the hole on the bottom or back of the frame where a strip is missing, so the strip sticks out from the frame. ![]() Stick a screw through the center of this point. The end of the strip will be a 90-degree point. ![]() Fold this side down so it is perpendicular to the side of the webbing. Fold the end of the strip at a 45-degree angle so the top of the strip is touching the side of the strip. If you're using clips, fold 3/4 inch (2 cm) of strap around the clip and insert it in the slot (again, you should be able to see from the old webbing how to do this).Cut your strips to these measurements. Screw in one end of the strap, pull it around tightly, and screw in the other end. Make a hole with an awl or screw about 1/2 inch (12 mm) from the tip of the point. If you are using clips, add 1 1/2 inches (4 cm).įor chairs with screws, fold down the corners at one end of the strap to form a point (you'll be able to see from the old webbing how this is done). If you are attaching the horizontal straps with screws, add 2 inches (5 cm) to each measurement, and cut the roll into strips of that length with scissors. Remember, the chair back and seat may not be the same width, so take measurements for each. Using the method described in step 2, above, measure the distance from the slots or holes for each of the horizontal straps. If the chair has a drooping seat or many frayed straps, you'll need to remove all the webbing. If only one or two straps are torn and the rest look good, you may want to replace only them. With a screwdriver, remove the screws or metal clips holding the webbing. Loop the other end of the strap around the other side of the frame, pull tightly and attach in the same manner. If you are using plastic rivets, you'll need to drive them in with a rubber mallet or very gently with a hammer. With an awl or the point of a screw, make a hole about 1/4 inch (6 mm) from each end of the strap.Īttach one end of the strap with a sheet-metal screw (see A). This will ensure that you stretch the strap as tightly as possible when installing it. Cut a length of strap 1 inch (2.5 cm) shorter than your measurement.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |